BMP280

Hex version CircleCI

Read temperature and pressure from Bosch BMP280, BME280, and BME680 sensors in Elixir.

Usage

Here's an example use (most sensors are at address 0x77, but some are at 0x76):

iex> {:ok, bmp} = BMP280.start_link(bus_name: "i2c-1", bus_address: 0x77)
{:ok, #PID<0.29929.0>}
iex> BMP280.measure(bmp)
{:ok,
 %BMP280.Measurement{
   altitude_m: 138.96206905098805,
   dew_point_c: 2.629181073094435,
   gas_resistance_ohms: 65538.59364451322,
   humidity_rh: 34.39681642351278,
   pressure_pa: 100818.86273677988,
   temperature_c: 18.645856498100876,
   timestamp_ms: 885906
 }}

Depending on your hardware configuration, you may need to modify the call to BMP280.start_link/1. See BMP280.options/0 for parameters.

All measurements are reported in SI units.

The altitude measurement is computed from the measured barometric pressure. To be accurate, it requires either the current sea level pressure or the current altitude. Here's an example:

iex> BMP280.force_altitude(bmp, 100)
:ok

Subsequent altitude reports should be more accurate until the weather changes.

Support for other Bosch barometric sensors

Other Bosch sensors tend to look similar, but they have enough differences that they do not work yet. If you're using one of them, please help me by either verifying that they work or adding support for them.